[cisco-voip] Trunk-Groups and Dialpeers - C3745
James Cornman
james at atlanticmetro.net
Fri Jun 27 09:33:45 EDT 2008
Hello.
I've got a Cisco 3745 with 4 CT1's on it. I've got them configured in
a trunk group. I'd like to have it so if the trunk group is full, send
any requests out to another device via SIP. I've attempted to do this
with different preferences on two dial-peers.
As it is, calls are coming in via SIP and then get dished out to the
trunk group with a configuration similar to below:
trunk group 1091
hunt-scheme round-robin
!
controller T1 0/1
framing esf
clock source internal
linecode b8zs
cablelength short 133
pri-group timeslots 1-24
!
(remaining 3 PRIs have same configuration)
interface Serial0/1:23
no ip address
encapsulation hdlc
isdn switch-type primary-ni
isdn protocol-emulate network
isdn incoming-voice voice
trunk-group 1091
no cdp enabl
e
!
(remaining 3 Serial interfaces have same configuration)
voice-port 0/1:23
!
dial-peer voice 10910101 pots
trunkgroup 1091
preference 1
destination-pattern 12124571234
forward-digits all
!
dial-peer voice 10910102 voip
preference 2
destination-pattern 12124571234
session protocol sipv2
session target dns:xxxx.atlanticmetro.net
dtmf-relay rtp-nte
codec g711ulaw
no vad
supplementary-service pass-through
!
Now, I've done some debugging and the trunk does recognize it is out
of capacity, however it returns an error instead of going to the
second preference dial-peer. I have confirmed via a debug voice
dialpeer that both dial-peers do match and have the proper preference.
I'm not sure how to accomplish this if the trunkgroup being full isnt
enough to signify moving on to the second dial-peer. Does anyone have
any advice?
Thank You
--
James Cornman
Chief Technical Officer
Atlantic Metro Communications
e: james at atlanticmetro.net
w: http://www.atlanticmetro.net
v: 212-792-9950
f: 718-559-4862
More information about the cisco-voip
mailing list