I think you should use another feature set, c7200-p-m means you use
service provider feature set, and vlan trunk is supported any other
feature set but service provider. Try the ip only - c7200-is, or
enterprise - c7200-js images...
Attila
On Wed, 24 Apr 2002, Ryan Spott wrote:
> Here is what I have:
>
> sho diag
> Slot 0:
> Fast-ethernet on C7200 I/O card with MII or RJ45 Port adapter, 1 port
>
> sho ver
> Cisco Internetwork Operating System Software
> IOS (tm) 7200 Software (C7200-P-M), Version 12.1(2), RELEASE SOFTWARE (fc1)
>
> Here is what I want:
>
> Router(config-if)#int fa 0/0.46
> Router(config-subif)#encapsulation dot1Q 46
> ^
> % Invalid input detected at '^' marker.
> Router(config-subif)#
>
> In the end I just want to run 2 subinterfaces off of this one so I
> can do some "routing on a stick." :)
>
> Am I just setting this up incorrectly or what?
> I am assuming I cannot configure VLANs on the built-in FE port on the
> management blade of a Cisco 7206. Is this true or am I missing
> something?
>
> thanks in advance!
>
>
> ryan
>
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:11:55 EDT