[nsp] VLAN Troubles on 7206

• Next message: Barry Bruins: "Re: snmp"
• Previous message: Tejal Shah: "[nsp] 7206 crash ! ! !"
• Next in thread: Chris Parker: "Re: [nsp] VLAN Troubles on 7206"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Here is what I have:

sho diag
Slot 0:
         Fast-ethernet on C7200 I/O card with MII or RJ45 Port adapter, 1 port

sho ver
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-P-M), Version 12.1(2), RELEASE SOFTWARE (fc1)

Here is what I want:

Router(config-if)#int fa 0/0.46
Router(config-subif)#encapsulation dot1Q 46
                              ^
% Invalid input detected at '^' marker.
Router(config-subif)#

In the end I just want to run 2 subinterfaces off of this one so I
can do some "routing on a stick." :)

Am I just setting this up incorrectly or what?
I am assuming I cannot configure VLANs on the built-in FE port on the
management blade of a Cisco 7206. Is this true or am I missing
something?

thanks in advance!

ryan

• Next message: Barry Bruins: "Re: snmp"
• Previous message: Tejal Shah: "[nsp] 7206 crash ! ! !"
• Next in thread: Chris Parker: "Re: [nsp] VLAN Troubles on 7206"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:42 EDT