On Tue, Nov 20, 2001 at 04:22:17PM -0500, Yuval Ben-Ari wrote:
> Niels,
> According to following URL what you are saying is not configurable:
> http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_6_2/_con
> fig/channel.htm#23937
>
> "EtherChannel distributes frames across the links in a channel based on
> the low-order bits of the source and destination Media Access Control
> (MAC) addresses of each frame. The frame distribution method is not
> configurable."
>
> It is possible, however, to manipulate MAC addresses.
FYI: etherchannel on *router* side would load-balance based on hash of
source/dest _IP_ address. It implies that if you run etherchannel between
router and a switch (we're talking Cisco here), and most of the traffic
heading into router would be coming from one layer2 point (say, gateway
router), it will occupy one of etherchannel links, but return traffic (from
router into switch) will load-balance. ;) Extremely useless. ;)
SY,
-- CCNP, CCDP (R&S) Dmitri E. Kalintsev CDPlayer@irc Network Architect @ connect.com.au dek @ connect.com.au phone: +61 3 9674 3913 fax: 9251 3666 http://-UNAVAIL- UIN:7150410 cell: +61 414 821 382
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:24 EDT