Re: [nsp] Using MRTG to get traffic on POS interface

From: Mikael Abrahamsson (swmike@swm.pp.se)
Date: Thu Jan 10 2002 - 03:11:56 EST

Next message: Cheung, Rick: "[nsp] MLS"
Previous message: Yosi Zaharur: "[nsp] Using MRTG to get traffic on POS interface"
In reply to: Yosi Zaharur: "[nsp] Using MRTG to get traffic on POS interface"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

On Thu, 10 Jan 2002, Yosi Zaharur wrote:

> In both I get the same result, the value drops to less then 10Mb when the
> line is loaded close to full 155Mb.

You have to use SNMPv2 when speeds go over 30-50 megabit/second.

Just add :::::2 after the snmpid:community@ip, ue:

Target[ip.snmpid]: snmpid:community@ip:::::2

You can use the same when you use cfgmaker, it'll handle it automatically.

-- 
Mikael Abrahamsson    email: swmike@swm.pp.se

Next message: Cheung, Rick: "[nsp] MLS"
Previous message: Yosi Zaharur: "[nsp] Using MRTG to get traffic on POS interface"
In reply to: Yosi Zaharur: "[nsp] Using MRTG to get traffic on POS interface"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:28 EDT