[nsp] Using MRTG to get traffic on POS interface

• Next message: Mikael Abrahamsson: "Re: [nsp] Using MRTG to get traffic on POS interface"
• Previous message: Raymond Leung: "[nsp] [nsp]Re: [nsp] Asking a question regarding on 2 line of VPDN session multilink"
• Next in thread: Mikael Abrahamsson: "Re: [nsp] Using MRTG to get traffic on POS interface"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Hi,

I'm having problems getting the correct value of traffic on POS interfaces
on a cisco GSR 12000 router.
It seems that whenever the interface is close to full-load I get much lower
values.
The interface type is POS, 155Mb

I tried getting this information via SNMP using MRTG with 2 ways :

Target[1] : /interface_ip_address:community@routerip

And
Target [2] : / 1.3.6.1.2.1.2.2.1.10.ifNumber
&1.3.6.1.2.1.2.2.1.16.ifNumber:community@routerip

I use a default MaxBytes[_]: 10000000000

In both I get the same result, the value drops to less then 10Mb when the
line is loaded close to full 155Mb.

Is there a better way /mib/oid to get information on such an interface ?

Thanks

Yossi Zaharur yosiz@bezeqint.co.il
<mailto:yosiz@bezeqint.co.il>
Infrastructure & Technologies Office: (972)-3-9203002
Internet Dep. Mobile: (972)-51-921136
Bezeq International Fax : (972)-3-9203028
http://games.bezeqint.net <http://games.bezeqint.net>
http://tucows.bezeqint.net <http://tucows.bezeqint.net>
 

• Next message: Mikael Abrahamsson: "Re: [nsp] Using MRTG to get traffic on POS interface"
• Previous message: Raymond Leung: "[nsp] [nsp]Re: [nsp] Asking a question regarding on 2 line of VPDN session multilink"
• Next in thread: Mikael Abrahamsson: "Re: [nsp] Using MRTG to get traffic on POS interface"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:28 EDT