Re: [nsp] car on dot1q fastethernet subinterface

From: Charles Sprickman (spork@inch.com)
Date: Wed Jan 23 2002 - 13:28:44 EST

Next message: Jared Mauch: "Re: [nsp] car on dot1q fastethernet subinterface"
Previous message: Robert J. Adams: "Source routing"
In reply to: Benjie Ko: "[nsp] car on dot1q fastethernet subinterface"
Next in thread: Blaz Zupan: "Re: [nsp] car on dot1q fastethernet subinterface"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Same question, but with 12.0(20)S...

Thanks,

Charles

On Wed, 23 Jan 2002, Benjie Ko wrote:

> Hello,
>
> Is car/cef supported on an encap dot1q fastethernet
> subinterface? hardware is 7500 with IOS 12.1(10). I
> have a 2 port FE card.
> If yes, since car can do rate limiting on each
> interface, does it follow that I can rate limit on
> each subinterface or do i need to configure a per ip
> rate limit on the main interface itself?
> Thanks.
>
>
> __________________________________________________
> Do You Yahoo!?
> Send FREE video emails in Yahoo! Mail!
> http://promo.yahoo.com/videomail/
>

Next message: Jared Mauch: "Re: [nsp] car on dot1q fastethernet subinterface"
Previous message: Robert J. Adams: "Source routing"
In reply to: Benjie Ko: "[nsp] car on dot1q fastethernet subinterface"
Next in thread: Blaz Zupan: "Re: [nsp] car on dot1q fastethernet subinterface"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:29 EDT