Oops, actually mine's the single port, read too fast.
I need to do dot1q on there with the S train and was curious if I had to
go into a more mainstream release to get CEF on the interface. I also
recall some conversations here about not being able to get stats on dot1q
interfaces, I assume that's still true on this software release...
Thanks,
Charles
| Charles Sprickman | Internet Channel
| INCH System Administration Team | (212)243-5200
| spork@inch.com | access@inch.com
On Wed, 23 Jan 2002, Jared Mauch wrote:
> On Wed, Jan 23, 2002 at 01:28:44PM -0500, Charles Sprickman wrote:
> > Same question, but with 12.0(20)S...
> >
> > Thanks,
> >
> > Charles
> >
> > | Charles Sprickman | Internet Channel
> > | INCH System Administration Team | (212)243-5200
> > | spork@inch.com | access@inch.com
> >
> > On Wed, 23 Jan 2002, Benjie Ko wrote:
> >
> > > Hello,
> > >
> > > Is car/cef supported on an encap dot1q fastethernet
> > > subinterface? hardware is 7500 with IOS 12.1(10). I
> > > have a 2 port FE card.
> > > If yes, since car can do rate limiting on each
> > > interface, does it follow that I can rate limit on
> > > each subinterface or do i need to configure a per ip
> > > rate limit on the main interface itself?
> > > Thanks.
>
>
> http://www.cisco.com/warp/public/770/fn17399.shtml
>
> You probally want to check that you don't have this PA.
>
> Cisco is removing support for it.
>
> > >
> > >
> > > __________________________________________________
> > > Do You Yahoo!?
> > > Send FREE video emails in Yahoo! Mail!
> > > http://promo.yahoo.com/videomail/
> > >
>
> --
> Jared Mauch | pgp key available via finger from jared@puck.nether.net
> clue++; | http://puck.nether.net/~jared/ My statements are only mine.
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:29 EDT