Hello,
We run dCEF, route between dot1Q vlans. IOS is 12.1.12, hw is 7500
It's bridging what is supported since 12.1(3)T between dot1q vlans
--z.
-----Eredeti üzenet-----
Feladó: Blaz Zupan [mailto:blaz@amis.net]
Küldve: 2002. január 23. 21:32
Címzett: Benjie Ko
Másolatot kap: cisco-nsp@puck.nether.net
Tárgy: Re: [nsp] car on dot1q fastethernet subinterface
> Is car/cef supported on an encap dot1q fastethernet
> subinterface? hardware is 7500 with IOS 12.1(10). I
> have a 2 port FE card.
Yes for CAR, no for CEF. To route between dot1q VLANs you need at least
IOS
12.1(3)T.
> If yes, since car can do rate limiting on each
> interface, does it follow that I can rate limit on
> each subinterface or do i need to configure a per ip
> rate limit on the main interface itself?
You can put limits on subinterfaces and they will only limit traffic
going
through that subinterface.
Blaz Zupan, Medinet d.o.o, Trzaska 85, SI-2000 Maribor, Slovenia
E-mail: blaz@amis.net, Tel: +386 2 320 6320, Fax: +386 2 320 6325
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:31 EDT