I didn't say it had anything to do with clocking. I was just bringing up
a problem he might run into when wiring two PA-T3 ports together over a
short distance.
On Fri, 26 Apr 2002, Alex Rubenstein wrote:
>
> Thats called LBO (line build out) and has nothing to do with clocking.
>
>
> On Thu, 25 Apr 2002, jlewis@lewis.org wrote:
>
> > I've had trouble doing this on some occasions, supposedly due to cables
> > being too short and too much signal strength. Also, it seems some
> > PA-2T3's are more sensitive to this than others.
> >
> > On 25 Apr 2002, Robert E. Seastrom wrote:
> >
> > >
> > > Benjie Ko <gerwalk1@yahoo.com> writes:
> > >
> > > > now that is resolved, my client has a t3 card also
> > > > with coax interface. Is it possible to cross connect
> > > > both routers (coax to coax) w/o the use of a fiber
> > > > DSU? Routers are 20 feet apart.
> > > > Thanks again in advance.
> > >
> > > Yes, it works great (Tx on one end to Rx on the other). One end
> > > should be supplying clocking, and the other should be recovering
> > > clocking from the line.
> > >
> > > Makita#conf t
> > > Enter configuration commands, one per line. End with CNTL/Z.
> > > Makita(config)#int serial 4/0
> > > Makita(config-if)#clock source ?
> > > internal Use internal clock
> > > line Recover clock from line
> > >
> > > Makita(config-if)#clock source
>
> -- Alex Rubenstein, AR97, K2AHR, alex@nac.net, latency, Al Reuben --
> -- Net Access Corporation, 800-NET-ME-36, http://www.nac.net --
>
>
-- ---------------------------------------------------------------------- Jon Lewis *jlewis@lewis.org*| I route System Administrator | therefore you are Atlantic Net | _________ http://www.lewis.org/~jlewis/pgp for PGP public key_________
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:42 EDT