This is located from the Password recovery section on Cisco's website
(http://www.cisco.com/warp/public/701/61.html)... It has worked for me in
the past.
How to Simulate a Break Key Sequence
This is useful if your terminal emulator doesn't support the break key, or
if a bug prevents it from sending the correct signal (the hyperterminal
under Windows NT used to suffer from this behavior):
Connect to the router with the following terminal settings:
1200 baud rate
No parity
8 data bits
1 stop bit
No flow control
You no longer see any output on your screen. This is normal.
Power cycle (switch off and then on) the router and press the spacebar for
10-15 seconds. This generates a signal similar to the break sequence.
Disconnect your terminal and reconnect with a 9600 baud rate. You should now
be in ROM Monitor mode.
Sean
> -----Original Message-----
> From: Dave [mailto:dave@hawk-systems.com]
> Sent: Monday, May 06, 2002 9:16 AM
> To: Llena Crispi, Josep (bcn); cisco-nsp@puck.nether.net
> Subject: RE: [nsp] Reset password for Cisco 802 router, break not
> working
>
>
>
> Been there and done that... problem is the router does not
> appear to be
> responding to the break signals (have tried a variety)
> almost as if a registry
> value for acknowledging the break had been disabled.
>
> Dave
>
> >-----Original Message-----
> >From: Llena Crispi, Josep (bcn) [mailto:josep.llena@eltec.es]
> >Sent: Monday, May 06, 2002 11:40 AM
> >To: Dave; cisco-nsp@puck.nether.net
> >Subject: RE: [nsp] Reset password for Cisco 802 router, break not
> >working
> >
> >
> >
> >
> >From my experience, the recovery process in 800s series is a
> bit diferent
> >than in 2500s series and others.
> >
> >Obviously, you can find this info on Cisco´s website :
> >
> > http://www.cisco.com/warp/public/474/pswdrec_800.html
> >
> >
> >
> >Bye,
> >__josep
> >
> >
> >
> >> -----Mensaje original-----
> >> De: Dave [SMTP:dave@hawk-systems.com]
> >> Enviado el: lunes, 06 de mayo de 2002 17:12
> >> Para: cisco-nsp@puck.nether.net
> >> Asunto: [nsp] Reset password for Cisco 802 router,
> break not working
> >>
> >> Purchased some "previously enjoyed" Cisco 802 routers for CPE ISDN
> >> termination.
> >>
> >> unfortunately the seller did not remove passwords prior to
> shipping.
> >> Normally
> >> no biggie (have had to reset passwords on 26xx series
> routers, and 53xx
> >> NAss on
> >> numerous occasions), but the 802s in question do not seem to be
> >> recognizing the
> >> break sequence to give access to ROMMON.
> >>
> >> After trying to send the break we normally do, went
> through and mapped
> >> several
> >> others, including reconfiguring the console serial
> connection to simulate
> >> the
> >> break as described in documentation, all to no avail.
> >>
> >> Before shipping these back to the seller and demanding he
> wipe them, any
> >> alternatives?
> >>
> >> Thanks
> >>
> >> Dave
> >
> >
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:43 EDT