There are a couple ways to do the route collection you
want, both take the solution outside the scope of
cisco-nsp territory:
1. run a route server (RSd) instead of a router
2. use a Juniper (see "advertise-inactive" description
in the JunOS 4.0 routing config guide)
Cheers,
-Lane
Lane Patterson
Member Research Staff
Equinix, Inc.
> -----Original Message-----
> From: Neil J. McRae [mailto:neil@COLT.NET]
> Sent: Thursday, August 03, 2000 2:21 AM
> To: tkernen@deckpoint.ch
> Cc: cisco-nsp@puck.nether.net
> Subject: Re: [nsp] BGP route-views setup
>
>
>
> No because a router will only export whichever path it has installed
> in its forwarding table.
>
> >
> >
> > I've got a BGP route-views router running 5 BGP sessions
> from around our
> > network. All is ok except the fact that I only have the
> best route for
> > each session and I would like to get all the routes for a
> network entry
> > (ie: peering points with 10 differents routes for same
> network entry).
> >
> > Is there a command in the BGP config that allows me to
> specify that I
> > want to send to a neighbor all the routes?
> >
> > Thomas
> >
> >
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:15 EDT