I'm playing with the same in mrtg but for these oids there is no results.
When I query by snmpwalk there is also no result. If I add an extra . at the
beginning of the oid it is working fine. Is this possible to adding this
extra . in my mrtg config is a requirement?
Thank you
Laszlo
-----Original Message-----
From: Subodh Nijsure [mailto:subodh@best.com]
Sent: Thursday, November 09, 2000 4:38 PM
To: rsmith@firstnet.co.uk
Cc: cisco-nsp@puck.nether.net
Subject: Re: [nsp] a little help is required please
> Hi All,
>
> I was once told the mib in dotted decimal format for the total amount of
> lines on a 5300 and the total amount of lines used on a 5300.
>
> unfortunately during transit this has been lost.
>
> if any one can help it will be much appreciated...
>
> it is only to use mrtg to graph ports in use on the 5300
May be this url will help?
ftp://ftp.cisco.com/pub/mibs/oid/CISCO-MODEM-MGMT-MIB.oid
"cmSystemModemsAvailable" "1.3.6.1.4.1.9.9.47.1.1.7"
"cmSystemModemsUnavailable" "1.3.6.1.4.1.9.9.47.1.1.8"
"cmSystemModemsOffline" "1.3.6.1.4.1.9.9.47.1.1.9"
"cmSystemModemsDead" "1.3.6.1.4.1.9.9.47.1.1.10"
In MRTG you will have to add .0 at end.
/Subodh
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:22 EDT