Roy,
Is interface Serial 3/0/5:0 up/up? If not, the interface will not respond to
ping requests.
Devon
-----Original Message-----
From: Roy Reyes [mailto:r.reyes@wesolv.com.ph]
Sent: Tuesday, January 02, 2001 10:50 PM
To: cisco-nsp@puck.nether.net
Subject: [nsp] i can't ping my own interface
I'm using Cisco 7513 router with Controller E1 interface on the VIP2/50.
I
setup two point-to-point E1 link which is terminated on my 7513 E1
controller
and the other end is on the Cisco 3660 Controller E1 module. I limit the
timeslot of the two routers to 1-24 and also enable to use the timeslot 16.
The problem is when i ping my own serial interface on the serial 3/05/:0
7513 (serial 3/0/5:0 = controller 3/0/5) i'm getting a 0% success but when i
ping all of the interfaces on the 3660 it works fine. Aside from the
problem
pinging my own interface i observed everything works fine.
thanks,
roy
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:24 EDT