[nsp] Access list 700

• Next message: Davide Fazzone: "Set the numbering-type on the AS5300"
• Previous message: Martin, Christian: "RE: [nsp] GSR GE packet ignores"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Hi,
I have a problem with a Cisco 8540, I have applied an access list to filter
mac addresses.
Basically I need to allow access to one box only.

I have the following config:

bridge 1 protocol ieee

access-list 700 permit c8a2.2541.0125 0000.0000.0000
access-list 700 permit FFFF.FFFF.FFFF 0000.0000.0000
access-list 700 deny 0000.0000.0000 FFFF.FFFF.FFFF

on the interfaces I want to apply the filter I'm putting:

bridge-group 1 output-address-list 700

All the documentation I can find say this should work, but it does not.

I have tried this on several IOS versions but still get the same result.

Does any one have any suggestions??

Thanks in advance.

• Next message: Davide Fazzone: "Set the numbering-type on the AS5300"
• Previous message: Martin, Christian: "RE: [nsp] GSR GE packet ignores"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:29 EDT