Dear All,
In an MPLS network, I am trying to figure out the configuration to be used
on the Core routers (Non-edge) of the MPLS network supporting traffic
engineering using RSVP signalling. I am just listing a small
configuration. Kindly let me know if this would work, & whether this is
the only configuration that's required to be applied on the core routers.
hostname core
!
ip cef
mpls traffic-eng tunnels
!
interface e0/0
mpls traffic-eng tunnels
!
interface s0/0
mpls traffic-eng tunnels
!
interface loopback 0
ip address x.y.a.b
!
router ospf 1
mpls traffic-eng area 0
mpls traffic-eng router-id loop0
end
Kindly enlighten me.
With warm regards,
Vinod.
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:30 EDT