You also have to enable RSVP on the interfaces
int e0/0
ip rsvp bandwidth XXXXXX
On Thu, 22 Feb 2001, Vinod Anthony Joseph Cherunni wrote:
> Dear All,
>
> In an MPLS network, I am trying to figure out the configuration to be used
> on the Core routers (Non-edge) of the MPLS network supporting traffic
> engineering using RSVP signalling. I am just listing a small
> configuration. Kindly let me know if this would work, & whether this is
> the only configuration that's required to be applied on the core routers.
>
> hostname core
> !
> ip cef
> mpls traffic-eng tunnels
> !
> interface e0/0
> mpls traffic-eng tunnels
> !
> interface s0/0
> mpls traffic-eng tunnels
> !
> interface loopback 0
> ip address x.y.a.b
> !
> router ospf 1
> mpls traffic-eng area 0
> mpls traffic-eng router-id loop0
>
> end
>
> Kindly enlighten me.
>
> With warm regards,
>
> Vinod.
>
>
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:30 EDT