That's the card all right, running with 12.0.13.S. I'm upgrading to
12.0.15S-2 in a few days so we'll see if it's addressed in that release.
Thanks for the info.
Mike
On 3/15/01 9:22 AM, "Walter De Smedt" <wdesmedt@pandora.be> wrote:
> "Michael K. Smith" wrote:
>
>> Hello All:
>>
>> Is there a way to force an ethernet port to show up/up status even if there
>> is nothing connected. I've used "no keepalives" on a serial interface with
>> success but the same command doesn't appear to work with the FE port.
>>
>> Thanks for any comments.
>>
>> Mike
>
> Is the on a 8 port FE LC for a GSR? If this is the case, a bug report is open
> at Cisco for this issue. We ran into the same problems when we connected 2
> routers (GSR and 7206) with a cross cable. Both interfaces where set to 'no
> keepalive'. The interface staid up/up on the 7200 but line protocol went down
> on GSR. We were using IOS 12.014S.
>
> walter
>
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:32 EDT