Dear All,
For an MPLS deployment, as understood there are still many "tag" commands
which are yet to be replaced by the "mpls" equivalents. In order to enable
LDP instead of TDP on the MPLS core, what will be the command used.
The documents on Cisco's site state that the command is "mpls label-protocol [ tdp | ldp | both ]". But I am unable to find this command in the 12.0(7) IOS. What would need
to be done to enable LDP on the core routers.
Kindly advise.
With warm regards,
Vinod.
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:32 EDT