Re: [nsp] REG: PIX Failover Bundle.

From: Vinod Anthony Joseph Cherunni (vac@dsqworld.com)
Date: Fri Apr 20 2001 - 08:53:49 EDT

Next message: Desmarais, Jonathan: "RE: [nsp] Mapping MPLS VPN to a 802.1q VLAN"
Previous message: Vinod Anthony Joseph Cherunni: "[nsp] REG: PIX Failover Bundle."
Maybe in reply to: Vinod Anthony Joseph Cherunni: "[nsp] REG: PIX Failover Bundle."
Next in thread: Scott Morris: "RE: [nsp] REG: PIX Failover Bundle."
Reply: Scott Morris: "RE: [nsp] REG: PIX Failover Bundle."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Hi,

Thanks a lot for the advice. Just a couple of queries in mind.

In a config as below -

nameif ethernet0 outside security0
nameif ethernet1 inside security100
nameif ethernet2 dmz-web security60
nameif ethernet3 dmz-auth security3

Assuming I am not using NAT on any interfaces, & need to disable it. How
would I achieve the same on all my PIX interfaces.

Secondly it would be great if you could send me a sample config for the
PIX failover part.

With kind regards,
Vinod.

Next message: Desmarais, Jonathan: "RE: [nsp] Mapping MPLS VPN to a 802.1q VLAN"
Previous message: Vinod Anthony Joseph Cherunni: "[nsp] REG: PIX Failover Bundle."
Maybe in reply to: Vinod Anthony Joseph Cherunni: "[nsp] REG: PIX Failover Bundle."
Next in thread: Scott Morris: "RE: [nsp] REG: PIX Failover Bundle."
Reply: Scott Morris: "RE: [nsp] REG: PIX Failover Bundle."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:35 EDT