On Mon, 21 May 2001, Zaheer Aziz wrote:
> Steve,
>
> The redistribute trick will work, but question remains why the network
> statement under ospf is
> not picking up this interface.
I thought that the network statement was only to describe which interfaces
would be in the ospf area. Is this incorrect?
Thanks,
Charles
> taking a look at database and routing table may be good start
>
> please provide
>
> sh ip route 10.0.16.30
> sh ip ospf database router <router ID of R1>,
>
> repeat for R2
>
> It may have been the case that OSPF did not pick this interface by mistake,
> removing the network statement and
> reinsertion may trigger it
>
> Hope this helps
> Zaheer
>
>
>
> >-----Original Message-----
> >From: Chris Davis [mailto:chris.davis@computerjobs.com]
> >Sent: Monday, May 21, 2001 12:45 PM
> >To: 'steven.godfrey@intechnology.co.uk'; cisco-nsp@puck.nether.net
> >Subject: RE: [nsp] OSPF not distributing 1 interface
> >
> >
> >Hello,
> >
> >Try "redistribute static subnets" under "router ospf 10"
> >
> >Chris Davis
> >Site Engineer
> >www.ComputerJobs.com
> >Upgrade Your Future
> >
> >
> >
> >-----Original Message-----
> >From: Freeserve (E-mail) [mailto:steve@godus.freeserve.co.uk]
> >Sent: Monday, May 21, 2001 12:26 PM
> >To: cisco-nsp@puck.nether.net
> >Subject: [nsp] OSPF not distributing 1 interface
> >
> >
> >Hi,
> >I have a strange problem with OSPF.
> >
> >The config is a very simple one area, one network statement. I have a /30
> >joining to routers over Ethernet and basically neither of the routers is
> >redistributing this connected link into OPSF?
> >
> >The 2 routers have other connections in the same network range and these are
> >being redistributed ok to the other 10 routers on the network?
> >
> >If anyone has any ideas I would appreciate it.
> >
> >Here is the config:
> >
> >ROUTER 1:
> >
> >interface FastEthernet0/0
> > description ******* HG1-PE4 ********
> > ip address 10.0.16.30 255.255.255.252
> > ip ospf cost 5
> > duplex auto
> > speed auto
> > tag-switching mtu 1600
> > tag-switching ip
> > no cdp enable
> >
> >router ospf 10
> > log-adjacency-changes
> > network 10.0.0.0 0.255.255.255 area 0.0.0.0
> >
> >
> >ROUTER 2:
> >
> >interface FastEthernet2/1
> > description ****** HG1-PE5 ******
> > ip address 10.0.16.29 255.255.255.252
> > ip ospf cost 5
> > duplex auto
> > speed auto
> > tag-switching mtu 1600
> > tag-switching ip
> >
> >router ospf 10
> > log-adjacency-changes
> > passive-interface Serial3/0.2
> > network 10.0.0.0 0.255.255.255 area 0.0.0.0
> >
> >Thanks in advance
> >
> >Steve.
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:38 EDT