Re: [nsp] active bri calls

From: Ryan O'Connell (ryan@complicity.co.uk)
Date: Wed May 23 2001 - 16:15:23 EDT

Next message: Mati Gil: "RE: Scaling IPSec VPNs and Meshes ?"
Previous message: Erik Drost: "RE: Scaling IPSec VPNs and Meshes ?"
In reply to: Steve Yingst \(LMF Staff\): "[nsp] active bri calls"
Next in thread: Mati Gil: "RE: Scaling IPSec VPNs and Meshes ?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

On Wed, May 23, 2001 at 01:24:37PM -0400, Steve Yingst (LMF Staff) wrote:
> Out 555-4321 +.c5e0.0415 284 Unavail - 0
> Out 555-1111 +.c5e0.1379 273 Unavail - 0

Those numbers look like the tail end of MAC addresses. I'd guess the remote
router is giving out it's MAC address as a name during PPP negotiation and
authentication - this is probably something you need to change on the NetGear.
I notice these are outbound calls - you might be able to change the "name"
assigned to the device in the dialer map statements (Assuming you're using
Legacy DDR) but I'm not sure.

-- Ryan O'Connell - <ryan@complicity.co.uk> - http://www.complicity.co.uk

I'm not losing my mind, no I'm not changing my lines, I'm just learning new things with the passage of time

Next message: Mati Gil: "RE: Scaling IPSec VPNs and Meshes ?"
Previous message: Erik Drost: "RE: Scaling IPSec VPNs and Meshes ?"
In reply to: Steve Yingst \(LMF Staff\): "[nsp] active bri calls"
Next in thread: Mati Gil: "RE: Scaling IPSec VPNs and Meshes ?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:38 EDT