> just the command I've been looking for for last week but forgot to follow it
> up
> (though there is a slight error on the document,
> the command is only available on privilege-exec mode).
Good point - I assumed priv. mode based on the example, but I should
know better than to assume anything. :-) I'll add that bit to the
document. Thanks!
> the "if-con" command is not listed int the 7513 help. I need it
> to check our VIP2-50's CPU and memory. I'm still looking for possible
> caveats if any.
> Found one only for 12.0T for possible router reload if the "show line"
> command is issued.
Be very careful here. As with all undocumented IOS commands, there
are risks with each revision of the IOS code.
-- Rob Thomas http://www.cymru.com/~robt cmn_err(CE_PANIC, "Out of coffee...");
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:39 EDT