Hello,
>interface Serial4/1/0.1/1/1/1:0
I think this is like this:
A STM card is emulating E1 or T1 lines so:
serial 4/1/0.1/1/1/1:0
the slot/port/aggregate-unframed.1/K/L/M
where KLM identifies the E1 Channel number over the STM.
regards
----------------------------------------------------------------------------
----------------------------------------------------------------------------
----------------
PEREZ Stephane
Carrier IP Specialist
Nortel Networks
ATS IP Core Infrastructure
25, allee Pierre Ziller
06560 Valbonne, FRANCE
Phone: +33 4 92 96 18 05 Mail : mailto:perezs@nortelnetworks.com
Fax: +33 4 92 96 16 68 www : http://www.nortelnetworks.com
Esn: 296-1805 Intranet :
http://hector.europe.nortel.com
-----Original Message-----
From: Neil J. McRae [mailto:neil@COLT.NET]
Sent: Tuesday, May 29, 2001 5:52 PM
To: cisco-nsp@puck.nether.net
Subject: [nsp] Channelised STM-1 card
FYI, Our Belgique IP engineering group successfully tested a STM-1
channelised connection using an E1 channel.
Hows about this for an interface descriptor:
interface Serial4/1/0.1/1/1/1:0
Regards,
Neil.
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:39 EDT