Just to underline that not all GEIP are VIP4, some (older?) are
VIP2-50:
cisco VIP2 R5K (R5000) processor (revision 0x02) with 131072K bytes of
memory.
Processor board ID 00000000
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
1 GigabitEthernet/IEEE 802.3 interface(s)
where a VIP4-80 is more like:
cisco VIP4 RM7000 (RM7000-250MHz) processor (revision 0x02) with 262144K
bytes of memory.
Processor board ID 00000000
R7000 CPU at 250Mhz, Implementation 39, Rev 2.1, 256KB L2 Cache
1 ATM network interface(s)
Francois
--Francois Baligant _ Wanadoo Belgium NV/SA, Network Operation Center ( ) a subsidiary of France Telecom /_\/ Lozenberg 22 - B-1932 Zaventem francois@be.wanadoo.com (__/\ tel: +32 2 717 17 17 FB1-6BONE FB3122-RIPE fax: +32 2 717 17 77
- "if you hold a unix shell to your ear, do you hear the c?"
On Thu, 25 Oct 2001, George Robbins wrote:
> It's not "supported" at all, but will work in a VIP2/40, VIP2/50, VIP4/xx. > Doesn't work in a FEIP 8-), dunno about a FEIP2. > > Offically you need to use a GEIP or GEIP+, which is a VIP4 with a PA-GE > variant, the GEIP uses a standard PA-GE, the GEIP+ uses a dual-wide > variant. > > Your milage may vary... > > George > > > > From: Joe McGuckin <joe@monk.via.net> > > Date: Thu, 25 Oct 2001 13:29:36 -0700 (PDT) > > To: cisco-nsp@puck.nether.net > > Subject: [nsp] Is PA-GE supported on 7500 ? > > > > I know it is on the 7200VXR but I can't find any documentation > > that says that the PA-GE is supported on the 7500. > > > > If it is, which VIP needs to be used ? > > > > Thanks, > > > > Joe > > > > > > -- > > > > Joe McGuckin > > > > ViaNet Communications > > 994 San Antonio Road > > Palo Alto, CA 94303 > > > > Phone: 650-213-1302 > > Cell: 650-207-0372 > > Fax: 650-969-2124 > > > > >
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:53 EDT