SQUID does not support WCCPv2 (however there is an alpha patch
for that), but latest OOPS proxy server from CVS
will, including dynamic service groups.
Barry Raveendran Greene wrote about "RE: [nsp] REG: WCCP Version 2.0":
> Does Squid support WCCPv2 now?
>
> If not, use WCCPv1.
>
> -----Original Message-----
> From: Vinod Anthony Joseph Cherunni [mailto:vac@antarix.biz]
> Sent: Wednesday, January 02, 2002 5:33 AM
> To: cisco-nsp@puck.nether.net
> Subject: [nsp] REG: WCCP Version 2.0
>
>
>
> Dear All,
>
> I am trying to establish a WCCP channel between a Cisco 7206-VXR router,
> & a SQUID Proxy system. When i set the wccp version to 2.0 on the
> router, I find that the router id & the router detects itself as a WCCP
> router. But when i set the version to 2.0, I get the following output of
> the command "sh ip wccp" -
>
> Global WCCP information:
> Router information:
> Router Identifier: -not yet determined-
> Protocol Version: 2.0
>
> Service Identifier: web-cache
> Number of Cache Engines: 0
> Number of routers: 0
> Total Packets Redirected: 0
> Redirect access-list: -none-
> Total Packets Denied Redirect: 0
> Total Packets Unassigned: 0
> Group access-list: 9
> Total Messages Denied to Group: 0
> Total Authentication failures: 0
>
> Also i get an error msg as follows -
> "WCCP-EVNT:???:Unknown msg_type 7 on Tunnel0 from 192.168.123.2"
>
>
> Kindly advise.
>
> With warm regards,
>
> Vinod.
>
-- Best Regards Vladimir Ivaschenko Certified Linux Engineer (RHCE)
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:58 EDT