Does Squid support WCCPv2 now?
If not, use WCCPv1.
-----Original Message-----
From: Vinod Anthony Joseph Cherunni [mailto:vac@antarix.biz]
Sent: Wednesday, January 02, 2002 5:33 AM
To: cisco-nsp@puck.nether.net
Subject: [nsp] REG: WCCP Version 2.0
Dear All,
I am trying to establish a WCCP channel between a Cisco 7206-VXR router, &
a SQUID Proxy system. When i set the wccp version to 2.0 on the router, I
find that the router id & the router detects itself as a WCCP router. But
when i set the version to 2.0, I get the following output of the command "sh
ip wccp" -
Global WCCP information:
Router information:
Router Identifier: -not yet determined-
Protocol Version: 2.0
Service Identifier: web-cache
Number of Cache Engines: 0
Number of routers: 0
Total Packets Redirected: 0
Redirect access-list: -none-
Total Packets Denied Redirect: 0
Total Packets Unassigned: 0
Group access-list: 9
Total Messages Denied to Group: 0
Total Authentication failures: 0
Also i get an error msg as follows -
"WCCP-EVNT:???:Unknown msg_type 7 on Tunnel0 from 192.168.123.2"
Kindly advise.
With warm regards,
Vinod.
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:58 EDT