I think the minimum mcom firmware you have to have is 5.0.20 to get v.90. I
would run 5.3.30. IOS doesn't matter(just as long as it recognizes the
modems you should be allright).
Josh
----- Original Message -----
From: "JosepLlena" <jllena@agmglobal.net>
To: <cisco-nsp@puck.nether.net>
Sent: Wednesday, January 16, 2002 10:22 AM
Subject: [nsp] Minimum IOS for AS 5200 and Microcom modems supporting v90 ?
>
> Hi !,
>
>
> I´m thinking about updating our Cisco AS 5200 in order to make connections
> from analogue modems that supports v.90 (56000 bps).
>
> Which version of IOS valid for an AS 5200 with this memory capabilites
would
> support connections at 56000 (v.90) and also will be stable ?
>
>
>
> It has an interface Eth, a WAN interface connected to a E1 and a dual
> unbalanced 24 modem (56k) Microcom (image : "mcom-modem-dsp.3.3.20-42.0")
> running with an IOS 11.3 (7) T IP feature Pack Release.
>
> I think that we have 16 Mb Flash and 8 Mb RAM.
>
>
> Anyway, this is the output writing a "sh version" command :
>
> cisco AS5200 (68030) processor (revision F) with 8192K/4096K bytes of
> memory.
> Processor board ID 11819985
> Channelized E1, Version 1.0.
> Bridging software.
> X.25 software, Version 3.0.0.
> Primary Rate ISDN software, Version 1.1.
> Mother board with terminator card.
> 1 Ethernet/IEEE 802.3 interface(s)
> 33 Serial network interface(s)
> 24 terminal line(s)
> 2 Channelized E1/PRI port(s)
> 128K bytes of non-volatile configuration memory.
> 16384K bytes of processor board System flash (Read ONLY)
> 8192K bytes of processor board Boot flash (Read/Write)
>
>
>
>
>
>
> Thanks,
>
>
> __josep
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:59 EDT