Can you achieve this by defining a few policers with the desired
rate-limiting in a firewall filter, and associate those policers
to filter terms with the specific prefix-list?
Dmitri Kalintsev wrote:
>
> Hi Juniper people,
>
> Does anybody know if something does exist or planned:
>
> per-dest-rate-limit {
> prefix 1.2.3.0/24 max-rate 56kbps;
> prefix 4.3.2.0/20 max-rate 2mbps;
> }
>
> then apply this to inbound rate-limiter machine, and it would work like
> this: receive packet, look its destination IP address up in the table, apply
> rate-limit as per spec. Basically, say I have few IP blocks for my dial-up
> users, and I know for sure that none of these IP addresses will consume more
> than 56kbps at any point in time, so I police it that way.
>
> SY,
> --
> CCNP, CCDP (R&S) Dmitri E. Kalintsev
> CDPlayer@irc Network Architect @ connect.com.au
> dek @ connect.com.au phone: +61 3 9674 3913 fax: 9251 3666
> http://-UNAVAIL- UIN:7150410 cell: +61 414 821 382
>
This archive was generated by hypermail 2b29 : Mon Aug 05 2002 - 10:42:37 EDT