This is a typo in the docs....the config should actually look like this:
protocols {
isis {
export filter-on-voice-policy;
rib-group common;
interface so-2/2/2.0;
interface so-4/2/2.0 {
passive;
}
}
}
as you have shown the config this would imply entering the following
command:
set protocol isis passive
This is an invlaid command
milo
-----Original Message-----
From: xw [mailto:xiaowu23@yahoo.com]
Sent: Tuesday, January 08, 2002 4:51 PM
To: juniper-nsp@puck.nether.net
Subject: [j-nsp] ISIS - "passive"
I came across the following config when I was looking at an ISIS
routing instance in 5.1 Online Manual.
protocols {
isis {
rib-group common;
export filter-on-voice-policy;
interface so-2/2/2.0;
interface so-4/2/2.0;
passive;
}
}
My question is, why would we want to put "passive" here? If
"interface so-2/2/2.0 passive" I understand what we are supposed
to get but with the above configuration, are we telling the
router to set both interface as passive or for other purposes???
Any help will be very much appreciated.
XW
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
This archive was generated by hypermail 2b29 : Mon Aug 05 2002 - 10:42:38 EDT