Fernando,
You can only borrow from one loopback address. The primary one.
HTH
--sukesh
-----Original Message-----
From: Fernando Garcia [mailto:fgarcia@eurocomercial.es]
Sent: Wednesday, April 03, 2002 5:41 AM
To: 'juniper-nsp@puck.nether.net'
Subject: [j-nsp] VRF and loopback addresses
Hello all
I´m trying to setup te following configuration in a M20:
- a new routing instance to handle a private network (i.e. A VPN in only a
router).
- This private network will have point-to-point static interfaces (Vcc over
ATM interface) numbered link to other router.
- All the other interfaces of the routing instances will be also point to
point interfaces (Vcc over ATM interfaces) but unnumbered and will run OSPF
and ISIS.
>From the documentation, I understand that this unnumbered links will use
the
loopback address of the router. But I don't want it to use that address.
It's a different routing instance and I want it to use another address.
It's possible? How? (a link to the document that say how is enough).
Regards, Fernando
--------------------------------------------------------------------
Fernando Garcia | Email: fgarcia@eurocomercial.es
Eurocomercial Informatica | Tel: +34 91 435 96 87
Y Comunicaciones | http://www.eurocomercial.es/
--------------------------------------------------------------------
This archive was generated by hypermail 2b29 : Mon Aug 05 2002 - 10:42:40 EDT