[Boatanchors] Elmac AF-67 - Is V2 only for NFM?
gzook at yahoo.com
Wed Jan 1 11:02:05 EST 2014
The tube is a reactance modulator. If the power supply runs 6.3-volts for the heaters ("filaments"), then you should be able to remove the tube. But, if the power supply runs 12.6-volts for the heaters, the tube has to remain or else the series / parallel relationship will cause an unbalance in the voltage applied to the tubes.
On Tuesday, December 31, 2013 9:54 PM, "qrv at kd4e.com" <qrv at kd4e.com> wrote:
I'm studying the schematic of the Elmac AF-67.
Is the only purpose of V2 inside the VFO box for NFM?
If so may it, and the associated circuitry, be removed
without harm to the VFO?
That reduces heat in the vfo enclosure.
Or am I misreading the schematic?
David (NOT Dave) Colburn, KD4E - Nevils, Georgia USA
Safe & Secure Search Engine: duckduckgo.com
Android for Hams: groups.yahoo.com/group/hamdroid
Creative Tech: groups.yahoo.com/group/ham-macguyver
Raspi Alternative: groups.yahoo.com/group/beagleboneblack/
Restored to design-spec at Heaven's gate 1Cor15:22
Boatanchors mailing list
Boatanchors at puck.nether.net
More information about the Boatanchors