[cisco-bba] Problem traffic shaping individual PPPoE sessions on a Cisco 2621 XM running c2600-telco-mz.123-7.T3.bin

[Dennis Peng]

I don't think you can shape on the vtemplate when you are the LAC. If
this were the LNS, that would work. If you are doing PPPoEoA, you can
shape at the VC level.

Dennis

Whittle, Michael [michael.whittle at thus.net] wrote:
> 
> We have configured a Cisco 2621XM as a LAC in which we are terminating
> various PPPoE connections. At the moment the solution is working but the
> bandwidth that each PPPoE session uses is a bit of a free for all. We would
> like to limit each PPPoE session to not exceed 512k. I have found some good
> documentation on the Cisco site which says that this can be done using both
> , 'service policies' or 'traffic-shape rate' on the Virtual-Template
> interface. The router accepts the configuration without a problem but for
> some reason when we check the throughput it exceeds 512k.
> 
> The documentation on the web site bases it's examples on a Cisco 10000
> platform but I don't think that would make a difference in this case because
> all the commands we need are supported on the Cisco 2621XM. The IOS we are
> running is, 'c2600-telco-mz.123-7.T3.bin' which I'm wondering if it may be
> the problem here. The router we are using also supports Virtual-Template
> subinterfaces but for some reason if I apply the traffic shaping commands to
> the Virtual-Template I should see the commands displayed when I use the
> following command and I don't:
> 
> interface Virtual-Template1
>  description PPPoE Session
>  mtu 1492
>  bandwidth 512
>  ip unnumbered Loopback0
>  no peer default ip address
>  no keepalive
>  traffic-shape rate 512000 8000 8000 1000
> !
> 
> CPR00227-test#test virtual-template 1 subinterface
> Subinterfaces may be created using Virtual-Template1
> CPR00227-test# 
> 
> The example above should limit each PPPoE session to 512k but it doesn't
> seem to work. I have also tried the configuration below and it also isn't
> working:
> 
> policy-map PPPoE-SESSION-TRAFFIC
>  class class-default
>   police cir 512000 bc 96000 be 192000
>     conform-action transmit
>     exceed-action drop
>     violate-action drop
> !
> 
> interface Virtual-Template1
>  description PPPoE Session
>  mtu 1492
>  bandwidth 512
>  ip unnumbered Loopback0
>  service-policy input PPPoE-SESSION-TRAFFIC
>  service-policy output PPPoE-SESSION-TRAFFIC
>  no peer default ip address
>  no keepalive
> !
> 
> CPR00227-test#show policy-map interface Virtual-Template1
>  Virtual-Template1
> 
>   Service-policy input: PPPoE-SESSION-TRAFFIC
> 
>     Service policy content is displayed for cloned interfaces only such as
> vaccess and sessions
> 
>   Service-policy output: PPPoE-SESSION-TRAFFIC
> 
>     Service policy content is displayed for cloned interfaces only such as
> vaccess and sessions
> CPR00227-test#
> 
> Any idea what the problem could be?
> 
> Regards,
> Mike

> _______________________________________________
> cisco-bba mailing list
> cisco-bba at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-bba