[cisco-bba] Fw: dual adsl setup on 2600 not dialing

[Mark Jones]

----- Original Message ----- 
From: Mark Jones 
To: Ben Matthews 
Sent: Monday, March 26, 2007 1:40 PM
Subject: Re: [cisco-bba] dual adsl setup on 2600 not dialing


Tried that and still no go.


I tried shuting down the second atm interface , subinterface and dialer 2 and saving config and rebooting.

After reboot it still would not dial with dialer1 , but as soon as I un shut the other interface it dialed right up.

I am not sure if this is related but, the router enabled virtual-access 1 when I un shut the second atm interface. So my theory is that it is not enabling a virual access for use on dialer 1 for some reason.

Any other ideas as I now have two routers doing this.
  ----- Original Message ----- 
  From: Ben Matthews 
  To: Mark Jones 
  Sent: Friday, March 23, 2007 10:49 PM
  Subject: RE: [cisco-bba] dual adsl setup on 2600 not dialing


  Mark,

  Try using different dialer groups and pools for each dialer / atm interface.
  As this works on both 1700's and ISR's.

  Also if doing cef balancing you will need IOS > 12.4.10 as their was a cef load balancing bug that ment the routers wouldn't load balance over dialers correctly.

  Ben.



------------------------------------------------------------------------------
  From: cisco-bba-bounces at puck.nether.net [mailto:cisco-bba-bounces at puck.nether.net] On Behalf Of Mark Jones
  Sent: Friday, 23 March 2007 11:12 PM
  To: cisco-bba at puck.nether.net
  Subject: [cisco-bba] dual adsl setup on 2600 not dialing


  One other problem I hope someone can help with

  Heres the senario

  cisco 2611 with one wic-1adsl installed

  working great for about a year.

  Install second wic-1adsl

  Config second dialer interface and establish connection. Everything fine for about 20 minutes then dailer 1 drops. It will not reastablish. as far as I can tell it does not even try.

  debugging tried so far

  shutdown dialer 2 and atm0/1 
      result: still no dial on dialer 1

  completely erased config rebooted and rebuilt from scratch. 
      result: was able to bring dialer 1 up then dialer 2, If dialer 1 dropped for any reason will not attempt to reastablish


  The really wierd part is I have an Identicle setup in another location. and I mean 100% identicle except for obvious ip address differences and it works fine.


  Any ideas? I find it hard to believe it is a hardware issue.





  Mark Jones
  London Operations
  Managed Network Systems
  171 Queens Ave Suite 515
  London Ontario
  N6A 5J7
  519-679-5207


------------------------------------------------------------------------------
  Message protected by MailGuard: e-mail anti-virus, anti-spam and content filtering.
  http://www.mailguard.com.au/mg

  Report this message as spam  
   


------------------------------------------------------------------------------
  Message protected by MailGuard: e-mail anti-virus, anti-spam and content filtering.
  http://www.mailguard.com.au/mg
   
   



------------------------------------------------------------------------------


  No virus found in this incoming message.
  Checked by AVG Free Edition.
  Version: 7.5.446 / Virus Database: 268.18.17/730 - Release Date: 3/22/2007 7:44 AM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-bba/attachments/20070326/3edca07a/attachment.html