[cisco-nas] L2TP - va bandwidth

[Anastassios Chatzithomaoglou]

In a L2TP scenario where does the va interface get the bandwidth description from?

This is a PPPoA/L2TP customer (1024/256)

router#sh int vi707
Virtual-Access707 is up, line protocol is up
   Hardware is Virtual Access interface
   Description: ** FORTHNET **
   Interface is unnumbered. Using address of Loopback0 (x.x.x.x)
   MTU 1500 bytes, BW 622080 Kbit, DLY 100000 usec,
      reliability 255/255, txload 1/255, rxload 1/255

BW = 622080 Kbit



This is a template used for our L2TP customers

router#sh int virtual-template 3
Virtual-Template3 is down, line protocol is down
   Hardware is Virtual Template interface
   Description: ** FORTHNET **
   Interface is unnumbered. Using address of Loopback0 (x.x.x.x)
   MTU 1500 bytes, BW 100000 Kbit, DLY 100000 usec,
      reliability 255/255, txload 1/255, rxload 1/255

BW = 100000 Kbit


Is there a way i can have each va interface show each customer's dsl speed?

-- 
***********************************
    Chatzithomaoglou Anastasios
Network Design & Operations Center
           FORTHnet S.A.
       <achatz at forthnet.gr>
***********************************