[cisco-nas] AS5300 C7 signalling configuration

[Souphonh]

Dear Sir,

Thanks for your helpfull information. Yes we are going to use sc2200 as
signalling controller. But our application will be VoIP not PPP server.
Could you please suggest if the VoIP config is different from PPP
configuration for ss7 signalling.

Regards,
Souphonh
----- Original Message ----- 
From: "Oliver Boehmer (oboehmer)" <oboehmer at cisco.com>
To: "Souphonh" <souphonh at laopdr.com>
Cc: <cisco-nas at puck.nether.net>
Sent: Friday, November 28, 2003 6:17 PM
Subject: RE: [cisco-nas] AS5300 C7 signalling configuration


>
> Could you please suggest how can I confiugure AS5300 to use E1 C7
> (SS7) signalling connection to PSTN ?

Which signalling controller are you using (SC2200/PGW2200)? For
ISDN-Q931+/RLM connection to the SC2200, a configuration looks like
this:

isdn switch-type primary-ni
!
controller E1 0
 pri-group timeslots 1-31 nfas_d primary nfas_int 0 nfas_group 0
!
controller E1 1
 pri-group timeslots 1-31 nfas_d none nfas_int 1 nfas_group 0
[...]
!
interface Serial0:15
 no ip address
 encapsulation ppp
 ip mroute-cache
 no keepalive
 dialer rotary-group 1
 dialer-group 1
 no snmp trap link-status
 isdn switch-type primary-ni
 isdn incoming-voice modem
 isdn T203 10000
 isdn rlm-group 0
 no isdn send-status-enquiry
 isdn negotiate-bchan resend-setup
 no cdp enable
!
rlm group 0
 protocol rlm port 3002
 server server1
  link address <address-sc2200-1a> source Loopback0 weight 4
  link address <address-sc2200-1a> source Loopback1 weight 3
 server server2
  link address <address-sc2200-2a> source Loopback0 weight 2
  link address <address-sc2200-2b> Loopback1 weight 1
!


HTH,

oli