[cisco-nas] Lucent XL connection

[Balgansuren]

Hi,

We are using Cisco AS5300/AS5350 with 4E1/8E1 lines gateway and R2
digitall signaling used to connect with Alcatel E10/Siemens EWSD voice
switch/PBX.

And we are trying change configuration of Cisco AS5300/AS5350 using
ISDN PRI signaling with Lucent Excel switch.

We done configuration on Lucent Excel switch using incoming
"EuroISDN", outgoing "ISDN IE".

On Cisco side following:

!
controller E1 2
 pri-group timeslots 1-31
 description Connected to Excel switch span 9
!

!
interface Serial2:15
 no ip address
 isdn switch-type primary-net5
 isdn incoming-voice modem
 isdn send-alerting
 isdn sending-complete
 no cdp enable
!

E1 line never get up:

E1 2 is down.
  Applique type is Channelized E1 - balanced
  Description: Connected to Excel switch span 9
  Receiver has remote alarm.
  alarm-trigger is not set
  Version info of slot 0:  HW: 1, PLD Rev: 11
  Framer Version: 0x8

Manufacture Cookie Info:
 EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x4B,
 Board Hardware Version 3.1, Item Number 800-3881-02,
 Board Revision D31, Serial Number 27517409,
 PLD/ISP Version 0.1,  Manufacture Date 19-Dec-2001.

  Framing is CRC4, Line Code is HDB3, Clock Source is Internal.
  Data in current interval (159 seconds elapsed):
     0 Line Code Violations, 0 Path Code Violations
     0 Slip Secs, 159 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 159
Unavail Secs
  Total Data (last 40 15 minute intervals):
     0 Line Code Violations, 0 Path Code Violations,
     0 Slip Secs, 583 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 583
Unavail Secs

Could you send helpful advice? Also I didn't find any good
configuration/troubleshooting document on Cisco web.

Balgaa