[cisco-nas] Re: Lucent XL connection

[Aaron Leonard]

Your E1 is down; the other side is sending an alarm.

Start here: 
E1 PRI Troubleshooting
http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a70fc.shtml

Aaron

---

> Hi,

> We are using Cisco AS5300/AS5350 with 4E1/8E1 lines gateway and R2
> digitall signaling used to connect with Alcatel E10/Siemens EWSD voice
> switch/PBX.

> And we are trying change configuration of Cisco AS5300/AS5350 using
> ISDN PRI signaling with Lucent Excel switch.

> We done configuration on Lucent Excel switch using incoming
> "EuroISDN", outgoing "ISDN IE".

> On Cisco side following:

> !
> controller E1 2
>  pri-group timeslots 1-31
>  description Connected to Excel switch span 9
> !

> !
> interface Serial2:15
>  no ip address
>  isdn switch-type primary-net5
>  isdn incoming-voice modem
>  isdn send-alerting
>  isdn sending-complete
>  no cdp enable
> !

> E1 line never get up:

> E1 2 is down.
>   Applique type is Channelized E1 - balanced
>   Description: Connected to Excel switch span 9
>   Receiver has remote alarm.
>   alarm-trigger is not set
>   Version info of slot 0:  HW: 1, PLD Rev: 11
>   Framer Version: 0x8

> Manufacture Cookie Info:
>  EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x4B,
>  Board Hardware Version 3.1, Item Number 800-3881-02,
>  Board Revision D31, Serial Number 27517409,
>  PLD/ISP Version 0.1,  Manufacture Date 19-Dec-2001.

>   Framing is CRC4, Line Code is HDB3, Clock Source is Internal.
>   Data in current interval (159 seconds elapsed):
>      0 Line Code Violations, 0 Path Code Violations
>      0 Slip Secs, 159 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 159
> Unavail Secs
>   Total Data (last 40 15 minute intervals):
>      0 Line Code Violations, 0 Path Code Violations,
>      0 Slip Secs, 583 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
>      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 583
> Unavail Secs

> Could you send helpful advice? Also I didn't find any good
> configuration/troubleshooting document on Cisco web.

> Balgaa