[cisco-nas] MICA disconnect reason 0xDF06 while connected

[Souphonh]

Dear Aaron,

Thank you for your help. The grounding method is working for me.

Regards,
Souphonh
----- Original Message ----- 
From: "Aaron Leonard" <Aaron at cisco.com>
To: "Anastassios Chatzithomaoglou" <achatz at forthnet.gr>
Cc: <cisco-nas at puck.nether.net>
Sent: Thursday, September 18, 2003 11:41 PM
Subject: Re: [cisco-nas] MICA disconnect reason 0xDF06 while connected


> > In one of our AS5300 (mica 2.9.4.0) we get a lot of such disconnects:
>
> >       Disconnect Reason Info:  (0xDF06)
> >         Type (=6 ):  Tx (host to line) data flushing - OK
> >        Class (=31):  Requested by host
> >       Reason (=6 ):  network indicated disconnect
>
> > These disconnects can happen 5 mins after the user has connected or 30
mins after.
>
> > The strange thing is that we don't see any errors on the E1 circuit
(neither telco does).
>
> > Any idea what might be going on?
>
> This just means that we got a hangup signal from the TDM network for
> that call.  (For example, if you're using ISDN, this would be
> receipt of a Q.931 DISCONNECT.)
>
> If the user at the other end of the circuit INTENDED to hang up,
> then of course this is not a problem.  If he did NOT intend to
> hang up, then this is a problem.
>
> Such a problem could be caused by poor circuit quality and/or by
> bad client modem behavior.
>
> Aaron
> _______________________________________________
> cisco-nas mailing list
> cisco-nas at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nas
>