AW: [cisco-nas] Max. ring time for analog calls

[Aaron Leonard]

S7 should work ... you might want to go to current
portware (2.9.5.0) if you have old portware.  
Turn on signaling debugs with timestamps if you think
it's not behaving right.

Aaron

---

> Hi Aaron

> Thank's for your reply. I've already tested the S7, but this timer waits
> "only" for carrier detect. Ring time is still 60 seconds.

> Daniel

> -----Ursprüngliche Nachricht-----
> Von: Aaron Leonard [mailto:AARON at cisco.com]
> Gesendet: Donnerstag, 26. August 2004 18:50
> An: Daniel Ruch
> Cc: cisco-nas at puck.nether.net
> Betreff: Re: [cisco-nas] Max. ring time for analog calls

> > Hi there,

 

> > Cisco 3640 with Mica modems:

> > Is there a way to limit the max. ring time for outgoing analog calls?
> > Default ring time is appr. 60 sec. when the other side is not
> > answering the call. I'd like to decrease this time to 10-15 seconds.

 

> > Thank's for any help.

> Sounds like you're looking for S7.

> http://www.cisco.com/univercd/cc/td/doc/product/access/acs_serv/5300/sw_conf
> /sw_ports/at_set/atcmnds.htm#4061

> Remember that MICA isn't really listening for ringback tone to end in order
> to tell that the called party has answered ... it is relying upon IOS to see
> some answer supervision signal from the circuit switch (such as a Q.931
> CONNECT).

> Aaron