[cisco-nas] %NP_MD-3-TX_INBAND_MSG_FAILURE message

[Aaron Leonard]

What input/output queue sizes do you have set on your async interfaces?

If you set this on your group-async:
--input queue 30
--output queue 65
does the problem go away?

Aaron

---

> I have a 5350 (12.3(1a) + np.8.5.spe) and i'm getting quite a lot of messages like the one
> below:

> %NP_MD-3-TX_INBAND_MSG_FAILURE: Failed to send inband message for port 2/88 (enqueue fail
> for framing mode=1)
> %NP_MD-3-TX_INBAND_MSG_FAILURE: Failed to send inband message for port 2/63 (enqueue fail
> for framing mode=1)

> I have found 3 bugs (CSCdx36518, CSCdx06719, CSCdx75525) related, but 2 of them are
> refering to cpu load and the last one to memory problems, while this 5350 goes up until
> 15% cpu load and has no memory problems.
> Also, all bugs do not appear to apply to 12.3(1a) IOS.

> Could there be something else i'm missing?

> --
> ***************************************
>        Chatzithomaoglou Anastasios
> Network Design & Development Department
>               FORTHnet S.A.
>           <achatz at forthnet.gr>
> ***************************************

> _______________________________________________
> cisco-nas mailing list
> cisco-nas at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nas