[cisco-nas] %NP_MD-3-TX_INBAND_MSG_FAILURE message

[Tassos Chatzithomaoglou]

Aaron Leonard wrote:

> What input/output queue sizes do you have set on your async interfaces?
> 

default input (=10 ?)
20 output

> If you set this on your group-async:
> --input queue 30
> --output queue 65
> does the problem go away?
> 

I'll give it a try and see what happens...

> Aaron
> 
> ---
> 
> 
>>I have a 5350 (12.3(1a) + np.8.5.spe) and i'm getting quite a lot of messages like the one
>>below:
> 
> 
>>%NP_MD-3-TX_INBAND_MSG_FAILURE: Failed to send inband message for port 2/88 (enqueue fail
>>for framing mode=1)
>>%NP_MD-3-TX_INBAND_MSG_FAILURE: Failed to send inband message for port 2/63 (enqueue fail
>>for framing mode=1)
> 
> 
>>I have found 3 bugs (CSCdx36518, CSCdx06719, CSCdx75525) related, but 2 of them are
>>refering to cpu load and the last one to memory problems, while this 5350 goes up until
>>15% cpu load and has no memory problems.
>>Also, all bugs do not appear to apply to 12.3(1a) IOS.
> 
> 
>>Could there be something else i'm missing?
> 
> 
>>--
>>***************************************
>>       Chatzithomaoglou Anastasios
>>Network Design & Development Department
>>              FORTHnet S.A.
>>          <achatz at forthnet.gr>
>>***************************************
> 
> 
>>_______________________________________________
>>cisco-nas mailing list
>>cisco-nas at puck.nether.net
>>https://puck.nether.net/mailman/listinfo/cisco-nas
> 
> 

-- 
***************************************
       Chatzithomaoglou Anastasios
Network Design & Development Department
              FORTHnet S.A.
          <achatz at forthnet.gr>
***************************************