[cisco-nas] PRI Basi Check up

[Ahmed Haroun]

First of all , thank you for the response Gert.
The Service provider has provided 4 wires only, and they are asking us
to connect it to our equipment, we have the Cisco 3845 with 1-PORT
Channelized E1/T1/ISDN-PRI Network Module, and 30 Port Digital Modem
Network Module.
I don't know how to connect the line, the PRI card in the Cisco router
has an RJ 45, and there is 2 leds on it.
-----Original Message-----
From: Gert Doering [mailto:gert at greenie.muc.de]
Sent: Sunday, April 16, 2006 5:47 PM
To: Ahmed Haroun
Cc: cisco-nas at puck.nether.net
Subject: Re: [cisco-nas] PRI Basi Check up
Hi,
On Sun, Apr 16, 2006 at 02:48:41PM +0300, Ahmed Haroun wrote:
> What led should light when I insert the PRI line from the Service
> provider?
All the relevant ones.
(It would be a easier to give meaningful responses if you could provide
some information about the type of equipment that you're using... on
german PRI lines, the red "S2M/V2M" LED on the NTPM has to go *off*, and
usually some sort of "link" LED on the device goes on when all 4 wires
are wired correctly)
gert
--
USENET is *not* the non-clickable part of WWW!

//www.muc.de/~gert/
Gert Doering - Munich, Germany
gert at greenie.muc.de
fax: +49-89-35655025
gert at net.informatik.tu-muenchen.de