[nsp] router-switch port speed negotiation

[jlewis@lewis.org]

On Sat, 24 Aug 2002, Stephen Sprunk wrote:

> 2600's do not auto-negotiate.  You must hard-code both sides.

Don't do it well, or don't do it at all??

cisco 2620 (MPC860) processor (revision 0x102) with 53248K/12288K bytes of 
memory.

FastEthernet0/0 is up, line protocol is up 
  Hardware is AmdFE, address is 0002.fd39.2fc0 (bia 0002.fd39.2fc0)
  Internet address is xxxxxxxxxxxx
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, 
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 100Mb/s, 100BaseTX/FX

interface FastEthernet0/0
 ip address xxxxxxxxxxxx
 duplex auto
 speed auto

----------------------------------------------------------------------
 Jon Lewis *jlewis@lewis.org*|  I route
 System Administrator        |  therefore you are
 Atlantic Net                |  
_________ http://www.lewis.org/~jlewis/pgp for PGP public key_________