[nsp] Router startup

[Marcus Keane]

Aaron, presumably when you performed a password recovery you set the
config-register to 0x42? Did you set it back to 0x2102 after the
recovery?
Marcus.

-----Original Message-----
From: Aaron Lynch [mailto:a.list@ninewire.com]=20
Sent: 10 October 2002 16:32
To: cisco-nsp@puck.nether.net
Subject: [nsp] Router startup


Hi All,

I recently had to do a password recovery of my Cisco 2600 router, and I
think I may have messed something up:

I setup the config, then 'wr mem' and then do
'copy running-config startup-config'

t1 works

But; if I power cycle the router, the config is nuked. t1 doesn't work
:)

Apparently the 2600 is not using 'startup-config' when it boots.

Can anybody tell me how to setup the boot parameters to use the
startup-config file?

_______________________________________________
cisco-nsp mailing list  real_name)s@puck.nether.net
http://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/