[nsp] IBGP mesh and 'network' command

[Marcus Keane]

Tommy,

Not sure what the accepted wisdom is here, but if you only have one
border router announcing 10.0.0.0/8 and that router fails, then the
other border routers will withdraw the route even if the 10.0.0.0
network is still active.
Marcus.

-----Original Message-----
From: TMS [mailto:tomek@absolut.vinyl.pl]=20
Sent: 26 September 2002 16:20
To: cisco-nsp@puck.nether.net
Subject: [nsp] IBGP mesh and 'network' command


Hello
I configured IBGP mesh using three cisco routers. And I used 'network
10.0.0.0' (in "router bgp XXX" configuration) command on each router.
So, for now each router announcing 10.0.0.0/8 network to each other. Is
this correct ? Maybe I should use "network 10.0.0.0" only on one router
? Which method is correct ?

best regards,
Tommy
_______________________________________________
cisco-nsp mailing list  real_name)s@puck.nether.net
http://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/