[nsp] Serial number

[Nipper, Arnold]

Because that only works with IOS. For CatOS use "show version"


Regards, Arnold


----- Original Message ----- 
From: "John Tobias" <JTobias at gilead.com>
To: <cisco-nsp at puck.nether.net>
Sent: Thursday, April 17, 2003 6:58 PM
Subject: RE: [nsp] Serial number


> I tried "sh idprom backplane" on my two 6500s (6.4.5 and 7.3.1) and got
> "unrecognized command". Anyone know why that is?
> 
> John Tobias
> 
> -----Original Message-----
> From: sthaug at nethelp.no [mailto:sthaug at nethelp.no] 
> Sent: Thursday, April 17, 2003 12:27 AM
> To: jared at puck.nether.net
> Cc: cisco-nsp at puck.nether.net
> Subject: Re: [nsp] Serial number
> 
> > For the 6500:
> > 
> > sh idprom backplane
> > 
> > It would be nice if cisco could standardize this across all
> > their ios based platforms..
> 
> Lots of other opportunities for standardization too. My current pet
> peeve is the flash memory on the secondary (redundant) processor - 
> sec-slot0: on the GSR and slaveslot0: on 6500/native.
> 
> Steinar Haug, Nethelp consulting, sthaug at nethelp.no
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>