[nsp] No CLI available in Cat 1900 series ???

[jspam at netbahamas.com]

Sounds like you replaced the Enterprise firmware with the Standard
firmware. Maybe someone would be nice enough to give you a copy of the
enterprise, or you could contact Cisco.

On Sat, 19 Apr 2003, Sancho2k.net Lists wrote:

> I have a cat1900 series that i just bumped firmware up to 9.xx latest rev.
>
> Anyway, after tinkering around in the menu system, I find that my option
> for configuring through CLI is gone. There used to be an option for
> choosing configure though command line "[K]". I now have these choices only:
>
> ==========================================================
> Catalyst 1900 Management Console
> Copyright (c) Cisco Systems, Inc.  1993-1999
> All rights reserved.
> Standard Edition Software
> Ethernet Address:      00-30-19-1E-10-00
>
> PCA Number:            73-3123-04
> PCA Serial Number:     FAB033839GE
> Model Number:          WS-C1912C-EN
> System Serial Number:  FAB0340V1BA
> Power Supply S/N:      PHI0317032U
> PCB Serial Number:     FAB033839GE,73-3123-04
> -------------------------------------------------
>
> 1 user(s) now active on Management Console.
>
>      User Interface Menu
>
>      [M] Menus
>      [I] IP Configuration
>      [P] Console Password
>
> Enter Selection:  _
> ==========================================================
>
> I have reset switch to factory defaults too. I dislike the menu-based
> config, how can I recover my capability to configure through CLI?
>
>
> TIA for help.
>
> DS
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>