[nsp] testing WIC1-DSU-T1 w/ Kentrox DSU

[Pete Templin]

Verify framing, encoding, encapsulations on all nodes.
Verify timeslot assignments match on both ends.  Attempt HDLC encapsulation on both ends to help signal a timeslot map mismatch.
If Kentrox DataSmart, verify not software rev v1.51.  If v1.51, reset to defaults, retest.  Set the IP addressing on the unit, and load v1.52 before you next reset power to the unit.  BTDT

Pete Templin
Senior Staff Engineer
TexLink Communications
(210) 892-4183
pete.templin at texlink.com


-----Original Message-----
From: Eric L. Howard [mailto:elh at outreachnetworks.com]
Sent: Friday, August 08, 2003 12:53 PM
To: cisco-nsp at puck.nether.net
Subject: [nsp] testing WIC1-DSU-T1 w/ Kentrox DSU

In testing a wic1-dsu back to back w/ a Kentrox - any special cable pin-out
needed?

       ~elh

--
Eric L. Howard           e l h @ o u t r e a c h n e t w o r k s . c o m
------------------------------------------------------------------------
www.OutreachNetworks.com                                    313.297.9900
------------------------------------------------------------------------
JabberID: elh at jabber.org                 Advocate of the Theocratic Rule
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/