[nsp] 7304 NPE-G100 won't boot 12.2(18)S2?

[Andrew Fort]

Gert Doering wrote:

>On Wed, Dec 24, 2003 at 10:24:54AM +1100, Andrew Fort wrote:
>  
>
>>Self decompressing the image : 
>>######################################################################################################################################## 
>>[OK]
>>
>>*** TLB (Load/Fetch) Exception ***
>>Access address = 0x0
>>  PC = 0x00000000, SP = 0x80007e10, RA = 0x00000000
>>  Cause Reg = 0x00000008, Status Reg = 0x34408003
>>
>>monitor: command "boot" aborted due to exception
>>    
>>
>
>I've seen something similar with 12.0(18)S "-p" image on a 7200.  The
>"-is" image worked fine, and 12.0(18)S1 and S2 "-p" images worked fine
>as well.  Tested on two different 7200s (7200/NPE-225 and 7200VXR/NPE-300),
>same result.
>
>I came to the conclusion that the image was mis-built, and didn't do
>any further research about it.
>
>  
>
>>Anyone else see this?  I've tried -p- and -k91p- and they both show the 
>>same circumstances.  12.2(18)S works, as does 20S.
>>    
>>
>
>Have you tried "-is" (if it is available)?
>
>12.2S releases seem to be "somewhat interesting"...
>
>gert
>

I've just tried -is (c7300-is-mz.122-18.S2.bin) and it also crashes with 
the same conditions.  I haven't run through our test process of 
12.2(20)S on this platform but it looks like we might have to.. If 
anyone is at Cisco over the break and can confirm this in the lab and 
pull the 12.2(18)S2 7304 images if they're just plain broken, that'd be 
much appreciated.

-afort